Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
4383 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
geissele
JRH
GS
primaryArms
vortex
aim
RS
colt
midwest
Guns
fightlite
bravocompany
OSIGHT
silencerShop
Holosun
cz
brownells
DFC
palmetto
skd
magpul
springfield
4383 Online
Holosun
brownells
fightlite
Guns
DFC
silencerShop
OSIGHT
primaryArms
geissele
skd
aim
colt
JRH
vortex
cz
springfield
bravocompany
midwest
palmetto
GS
RS
magpul
Armory Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
2/5/2016 12:06:03 PM EDT
I have a new Ruger Precision Rifle in .308. I want to install a match grade barrel chambered in either 6.5 Creedmoor or 7mm-08.
I understand Ruger uses a barrel attachment system similar to Savage on this rifle. I have the wrench for the barrel nut and will buy the correct headspace go gauge. My question is, what is the best method to hold the receiver when removing and installing the barrel nut?

Thank you,
Steve
2/7/2016 5:48:00 PM EDT
[#1]
You might have good luck asking in the Roger Precision Rifle thread in the precision rifles section or over on snipers hide. I hear its not too hard of a swap, but they will know how to vise it for the swap.
Armory Sponsor
colt
LAPG
CA
Pro2A
primaryArms
blackhills
SAS
Faxxon
ar15com
brownells
LAPG
bravocompany
cmmg
RS
ar15com
ar15com
palmetto
silencerShop
geissele
gray
THBRD
springfield