Armory Sponsor
Posted: 1/30/2015 4:16:19 AM EDT
|
Where do you guy do your engraving?
What all do you put Name, city state, caliber? or multi? is the serial # required if it's already on the receiver am I missing any thing? |
|
^^ there's no 1/16" minimum requirement for anything except serial number ^^
OP...this gets covered over and over in this forum. Here's a recent thread that should cover it. |
|
Quoted:
I belive this to be false. Quoted:
Quoted:
If your gun is marked multi, it will need a caliber to. I belive this to be false. You can believe what you want, but the law would disagree. If the lower is marked "multi" and the upper/barrel doesn't have the caliber conspicuously placed, it has to be engraved. The clearest explanation of that is #5 in ATF Ruling 2013-3. |
|
Quoted:
Then there may be many non-compliant multis out there. Possible. A lot of factory short barrels/uppers are marked, which satisfies the requirement. I have one I had to mark because I lost the barrel markings when I had a 6.8 barrel cut down from 16" to 12", and the lower is a "multi". I simply added it between the pivot pin ears with a Dremel. |
Armory Sponsor