Armory Sponsor
Posted: 8/25/2016 3:47:22 PM EDT
| Will a drop in trigger work in the MPX or will it be too wide? |
| Looks like the Gen 2 BFS also works: https://youtu.be/mzlhBSy4NRQ |
|
Quoted:
Has anyone put a Larue MBT-2S into their MPX? I sent an e-mail asking them this question, and the response was that it wouldn't work. I thought AR compatible triggers work in the SIG MPX's.  Really? See my post..middle of page: https://www.ar15.com/forums/t_3_118/690757_LaRue_MBT.html&page=7 And....from the LaRue Forum: https://www.ar15.com/forums/t_2_219/275931_Hey_Larue__MBT_good_to_go_in_the_Sig_MPX_.html In short..the MBT works perfectly in my MPX....but I just took it out and swapped it with the FA BFS....BFS trigger pull sucks compared with the MPX. If Binary mode doesn't work perfectly.....I'm gonna reinstall the MBT. |
|
Hey, I asked before reading these threads, and that's the answer I got from Larue's Tech support.
Subject: RE: Form submission from: Product Question Charlie, Unfortunately I do not believe they will. V/R Brandon Technical Support 512-260-4513 [email protected] I figured I get the right answer from the horse's mouth. Hence the confusion!! |
|
not too bad for a $2K+ sub gun setup.. |
|
I've noticed when I swapped in a reworked mil-spec trigger, the "bridge" must be removed to allow the hammer to drop down far enough to get the bolt to function.
Seems to function just fine without it. BUT... Will there be issues down the road not having it installed? |
|
Quoted:
Has anyone put a Larue MBT-2S into their MPX? I sent an e-mail asking them this question, and the response was that it wouldn't work. I thought AR compatible triggers work in the SIG MPX's. 1854 rounds now fired with my MPX and the Larue MBT-2S trigger with zero problems. The SIG trigger "bridge" will not fit with the MBT, but no problems, no trigger slap, just a MUCH more pleasant and accurate to shoot MPX. Can see a slight polishing in the finish of the hammer where the carrier pushes back against the hammer as the gun cycles. Hammer face also looks to have a very slight dimple in it where it hits the firing pin (can see it, but can't feel it with my fingernail). |
Armory Sponsor