Armory Sponsor
Posted: 4/1/2012 7:35:31 AM EDT
|
Starting to work up my loads for the bullets I got from RMR and I just wanted to check with you guys if you think this sounds sufficient.....
All LC 1 fired brass. CCI small rifle primers. Ramshot TAC. 5 loads each. 22.3 grns, 22.9 grns, 23.4 grns, 24.0 grns, and 24.5 grns. I got this out of my Lee data book and looking at the Ramshot website for start and max values. Book states COL 2.22 Sounds good or am I missing something? Thanks for helping the rookie 
|
|
Quoted: Starting to work up my loads for the bullets I got from RMR and I just wanted to check with you guys if you think this sounds sufficient..... All LC 1 fired brass. CCI small rifle primers. Ramshot TAC. 5 loads each. 22.3 grns, 22.9 grns, 23.4 grns, 24.0 grns, and 24.5 grns. I got this out of my Lee data book and looking at the Ramshot website for start and max values. Book states COL 2.22 Sounds good or am I missing something? Thanks for helping the rookie  I seat SS-109's to mid cannelure, case trimmed to 1.750. I crimp these loads, most loads I don't. Mag length is 2.260, I like to be around 2.250 to be sure each round will feed from mag without fail. I suggest you go to a thicker cup primer if you want to work your load up to its full potential. CCI, 450, CCI 41, Rem 7 1/2, Wolf SRM (KVB556M). I use the Wolf primer. Don't work up your load any higher until you change primers. Don't expect stellar accuracy, these are not match bullets. I get 2 to 2 1/2 inch 10 shot 100 yard groups.  I have found the bullets with pull marks shoot as good as the ones without pull marks. Tac is my powder of choice with these bullets. Good luck |
Armory Sponsor