[ARCHIVED THREAD] - LNL Sizing Question

Posted: 12/31/2008 12:10:22 PM EDT

I just recieved my new LNL AP with EZject and got everything setup. I also got a set of new Hornady CGND dies for .223........the die instructions say to screw the die in to the shellplate, but don't screw so far that the press handle "cams" over. Well i did that and the sizing was not enough. So I did go ahead and screw down the die until it sized correctly, but it does have to cam over to do so. Is that OK?, the camming that is? On my Lee classic Turret press, It does not have to cam over to size my .223 brass.

Thanks in advace.......

Posted: 12/31/2008 8:07:13 PM EDT

[#1]

If you are talking rifle,, using some lube in the neck will allow you to not have to cam over as much if any.
'Borg

Posted: 12/31/2008 8:25:37 PM EDT

[#2]

With my New Demention dies, I had to screw it about an 1/8 or 3/16th of a turn pass the point where it touched the plate to get it to properly size my .223 brass. No problems noticed on several thousand reloads since.

[ARCHIVED THREAD] - LNL Sizing Question

Armory Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - LNL Sizing Question

[ARCHIVED THREAD] - LNL Sizing Question