Armory Sponsor
Posted: 7/6/2009 4:23:21 PM EDT
| I bought a 14.5" Rifle that has a flash ider on it to make it 16". Now the "pin" is ground down so i cant take i toff. If i wanted to make this into an SBR/change the flash hider can this be taken off? |
|
if you make it into a SBR, get your tax stamp then remove it.
If you wish to change the flash hider and not make a SBR, remove your flash hider, put the new one on, and either blind pin, pin&weld over, or 4 welds from the FH to barrel. This is required to meet the 16" min barrel length. |
|
Instructions on how to remove a permanently attached flash hider are about 3/4 of the way down on this page
http://www.ar15.com/forums/topic.html?b=3&f=4&t=226782 |
Armory Sponsor