Armory Sponsor
Posted: 3/22/2015 10:41:09 AM EDT
| I had my brake installed by my LGS a while back and after scrwing the supressor off the wrong way, the supressor began to screw off with the brake still attached. Was the brake installed incorrectly to come off like that? I just hand screwed it back tight. Do i need to take it to someone to work on it on or is hand tightening it fine? |
|
Quoted:
I had my brake installed by my LGS a while back and after scrwing the supressor off the wrong way, the supressor began to screw off with the brake still attached. Was the brake installed incorrectly to come off like that? I just hand screwed it back tight. Do i need to take it to someone to work on it on or is hand tightening it fine? It should have been installed with the Rockset that came with it. If the mount's coming loose that's not good. If it unscrews while shooting you could get a baffle strike. It's not that hard to install yourself if you've got the right tools, but if not, take it in. |
|
Quoted:
Ok I have been researching since I posted the OP. I am buying a torque wrench, acetone, and locksett off amazon. Do I need a new crush washer or can I just follow the directions for installing a new brake with the original parts? TIA No crush washers!!!! Only use shims. It should have come with them and I don't use a torque wrench when installing brakes or FHs. |
Armory Sponsor