Armory Sponsor
Posted: 7/4/2002 6:43:27 AM EDT
I think I finally decided to buy the stainless 20" Bushy but I would like to replace the front site with one of these  How hard is this to do? |
|
If you are ordering from Bushmaster have them put it on when you order. If not... -Drive out taper pins (left to right) -Pull off gas block -Remove rollpin and gas tube -Install gas tube and rollpin -Install new gas block/tube -Square top of gas block with top of receiver (use machinist protractor or level) -Snug set screws---If you want to set up/use irons -Install irons/Zero rear sight -Test fire and tilt gas block to get correct zero (windage) with rear sight -Final torque/loctite set screws at this time -If not using/fitting irons final torque at step 7 -You can install a sling swivel mt. in one of the set screw holes if you wish |
Armory Sponsor