Armory Sponsor
Posted: 6/28/2002 8:54:30 PM EDT
|
Its a pretty deep gouge. Liquid wood? Bondo? SOL? 
|
LMAO!! For the love of Pete man! Its a camp 9 carbine! My grandson (if I ever have one) will know better than to believe I ever brought a 9mm into bear country! He knows I'm a Ninja and we take on bear with just a leatherman! (watch the gif, the smiley turns into a Ninja) 
|
|
I never tried it but I heard about using water to swell the wood up then sanding it even. I think a glass rod was also used. The way I heard was using single drops of water right on the spot you want raised...repeating as necessary then after sanding (or glass rodding) it even you'll need to rematch the stain in that area and finish it. Or If I don't sell my camp carbine with the original stock I might have a new stock for sale......  John |
|
How are your woodworking skills? This requires a bit of skill, but it would be the "best" way. 1. Remove the action/barrel. 2 With a very sharp wood chisel, excise a small chunk of wood, slightly bigger than the gouge, from inside the stock (side of barrel bed). this will insure a matching repair. 3. CLEAN the gouge ( maybe make it a little deeper) and match the excised chunk of wood to the gouge. 4. Glue the piece of wood into the gouge...You want a very tight/matched fit w/ the grain going the right way. 5. Sand down to match the stock and refinish. |
|
Really does not look like its beyond the Steam technique.Wet a cloth till just damp,apply to wound and touch outer area of cloth with hot iron(cotton setting) to generate steam in/over the area.Go slowly,repeat till no further improvement.set aside to dry and then apply touch-up pen stain(available at Lowe's, Home Depot,hardware stores for fixing scratches in furniture).Go slow-apply pen till correct color is reached-use lightest pen color available to you and darken with repeated coats-not dark color at first.Worth a try before you cut/gouge/F-up anything.Its worked on old milsurp walnut stocks well.Regards |
Well see, it all started when I heard something out in my garage. My mini-gun was locked in the jeep so I grabbed the camp9 w/30 round mag. I stepped outside and saw two guys trying to steal my prized marble collection. I fired 30 rounds over their heads as fast as I could pull the trigger. When the smoke cleared they were gone and there were marbles everywhere. I walked to the garage and leaned the camp 9 up against the wall....and thats when it happened! It fell over and landed on the electric heater causeing a large gash in the wood stock. Thats how it happened, every word true. |
|
hey slacker, i work in a furniture store and have had some experience w/ dented, gouged, and even totally blown out wood. if i were you i would find your nearest furniture repair store and ask for a wood repair crayon (matching the color to your wood, of course). its a hard waxy crayon that once dry and if applied right will stay forever, and if matched correctly you wont see it unless you know its there. heres how to apply: use a lighter, melt it just overflowing into your gouge, use a credit card to flaten and slightly spread the wax blending it w/ your grain, once youve done that youll only see it because its matte instead of gloss, soooo-just use a gloss spray overcoat (like spray paint) and your gun can look as good as new. thats if your gun stock is worth $10.00'ish and 0.5 hours plus driving of your time. i hope that helped. sean |
Wow! Good thing they didn't get all the marbles! |
Armory Sponsor