Armory Sponsor
Posted: 1/18/2007 9:22:26 AM EDT
| I have already asked this question elsewhere but does anyone have the skull stencil that i've seen on several guns on this site? |
|
The punisher one? If so, just go to the local comic book store (or ebay) and pick up the vinyl decal/bumper sticker. Cut it out and then use that as a stencil. For stencils, I have cut out a stencil on ordinary paper, sprits a mist of water onto the piece to be spainted, placed the stencil on top where the water makes it "stick", blot out any water within the stencil area, then spray. This wet paper technique is better than using a temporary spray adhesive as clean up is easier. 
|
|
not very good at checking replies after you post are you? go to the link below and see on that page in the M4gery thread the stencil posted for it. I and others tried pointing it out to you but apparently you didn't see it. www.ar15.com/forums/topic.html?b=3&f=118&t=308980&page=9 eh wth i'll just put it on here...print the image out and then cut the black portions out. then hold stencil over desired object and apply rattle can.  
|
Armory Sponsor