Posted: 6/4/2008 5:29:34 PM EDT
|
While putting my grips back on the head of a grip screw sheared off leaving the body of the screw in the bushing. The slot on the bushing cannot be used to remove it now. Any ideas on how to get it off so I can replace it? |
|
File the screw flat, then drill a small hole in the center. Get a small head allen head wrench and some super glue. Fill the hole with the glue and insert the wrench. Wait for it to set up and then turn the screw out. This method worked for me with a broken screw head on a Beretta that I have. |
| Use a centerpunch to give yourself good point to start a drill without it wandering off. Get a left-handed twist drill from McMaster-Carr or MSC Direct of the corrrect diameter to remove the screw. Chuck it up in a reversable drill and have at it. More than likely it will back out as soon as the drill gets a bite in the screw. |
That's what I've done in the past as well. Just took a second. When you order new grip screws go ahead and get 4 news ones) order a new set of screw bushings as well, they're cheap and you'll have them on hand for next time as well. |
|
I'll third the grab it with vice grips and turn the whole bushing out. Another option is use a Dremel cut-off wheel to cut a slot in the screw that lines up with the bushing slot and use a screwdriver. Have to be careful not to score the frame with the cut wheel though. |
|
This was my first thought. Likely need a new screw bushing though. |
|
I've experienced head seperation on at least 6 different occasions. Hex head grip screws pretty much suck! If the hex socket is deep and large enough to preclude stripping, the integrity of the head is compromised. My favorite screws are the narrow slot ones from Kings. 
|
Not to mention those maintain the field repair of the weapon. With the slot screws you can strip to bare frame and slide with no tools. |
| I have seen it twice in the shop. Both I got out using a sharp pointed tool by taping it out in a chisel affect in the reverse or out direction. Worked both times no harm to the bushing. I did it once with a ball point pen . I rotated it out far enough then I just push my finger down on the screw and backed it out. I allways try to find the easy way out with anything before I bring out the power tools. |