Posted: 1/27/2016 10:52:14 PM EDT
|
I just managed to lose one on the locking washers between the grip and the underside of the screw head on a 92 FS and I don't see these on Brownells site, who has these and could I use a small o ring if I can't come up with these locking washers ?
Thanks. |
|
Quoted:
I just managed to lose one on the locking washers between the grip and the underside of the screw head on a 92 FS and I don't see these on Brownells site, who has these and could I use a small o ring if I can't come up with these locking washers ? Thanks. My vz grips came with an o rign and they held up just fine. http://www.midwestgunworks.com/page/mgwi/prod/beretta-90-series-grip-screws/EU00015 Here's the closest I've found, if you don't have allen screws now you will! 
|
|
Thanks Guys, I went to the hardware store this morning armed with a set of calipers and picked up some neoprene washers, some star lock washers and some O rings. I'm starting out with the o rings (BTW the o rings are a #47) but I will probably go ahead and order the stuff from Beretta to have on hand.
Thanks again. |
|
Quoted:
Thanks Guys, I went to the hardware store this morning armed with a set of calipers and picked up some neoprene washers, some star lock washers and some O rings. I'm starting out with the o rings (BTW the o rings are a #47) but I will probably go ahead and order the stuff from Beretta to have on hand. Thanks again. You can live without them just fine if you just check your gun over from time to time. Beretta put them there specifically for the military because they knew that military guns would get nothing but abuse. But us civvies tend to actually take care of our stuff. I wouldn't lose any sleep over it |