Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 12/25/2005 9:45:32 PM EDT
I am preparing to buy a rear sight tool for the glock pistols. Obviously the factory models are an option. I am also looking at the MGW, PI Inc, and the one offered by Glockmeister. I was wondering which ones any one has used. Any recommendations would be helpful. Thanks guys.
Link Posted: 12/25/2005 9:51:53 PM EDT
I had both Glock sight tools, sold them for an adjustable tool, may have been the Glockmeister one. Seems like every time I got around shooting buddies or gun shows, somebody needed a set of sights pressed on or off. The Glock tools work on Glocks only, may on others with a prayer. Go with the adjustable.
Link Posted: 12/25/2005 11:15:59 PM EDT
I have both the Glock sight tools(large frame & small frame) and the MGW. I use the MGW way more then the factory tools. I had a chance to buy the one from Glockmeister but opted out after reading some not so favorable post about them on another forum.
Link Posted: 12/26/2005 6:39:46 AM EDT
MGW it is. Thanks alot guys!
Link Posted: 12/26/2005 10:16:47 AM EDT
I have the Glockmiester tool. Glockmiester had a deal were I got the sights at a decent discount if I bought the tool (which I wanted), so I did.

My only complaint, is that the front sight tool came badly damaged. I contacted Glockmiester and asked them to replace it. They said that I should mail it to them and they'd "check into it?" Their tone and response, made it sound like it was going to be a huge battle to replace the simple tool. Since I had other nut-drivers that worked just fine, I opted to just not send the damaged one in.

The rear sight tool has served me very well though!
Link Posted: 12/26/2005 12:11:20 PM EDT
The MGW tool is great. Remember though it now comes in two flavors. One for slope sided sites such as Meprolights, and Trijicons, the other for straight wall sites such as Heinies, Ghost Ring sites, etc.
Top Top