AK Sponsor
Posted: 10/2/2009 3:57:13 PM EDT
|
Can someone give me a close up shot of the left side of their gas block on their M70 (the side with the nut on it)?
Since my nut was stripped completely minus a small thread at the top of it, I cant assemble the gas cutoff, but I did buy a new nut at the hardware store that fits - but I cant figure out if the washer fits on the inside or outside of the grenade sight. If I put it on the outside, I cant seem to tighten the nut very far and there is a gap (like there was before) between the sight and the gasblock where gas is going to escape. Which I am not sure if that is normal or not since mine had the gap, I had some gas escaping around that part of my rifle, as evidenced by some streaks around the hole on the gas block. |
|
Quoted:
My three M70s all have the washer on the outside of the sight (next to the nut). There is no gap on any of them. Interesting - the gap on mine is so big I could actually fit the washer there. Can you post a picture of the gasblock/sight on the nut side close up? |
AK Sponsor