AK Sponsor
Posted: 12/11/2005 12:10:54 PM EDT
|
hey all, I just picked up a used norinco sks. looks to be in good condition. i'm just about to give it a cleaning but I cant get the recever cover off. I've checked the surplusrifle.com and am following there directions. the mag is hanging out, the recever cover pin is in the 7 oclock position and pulled out. it wont go any further. can anyone please help me out? thanks |
|
thanks for the info. I got it off and cleaned finally. does anyone know of a good way to refinish the metal and the wood of these guns? the rifle looks ok now but the finish is almost totaly off the recever cover. it looks like it;s polished chrome. same as the bolt carrier. the wood is in excellent condition. it's a reg type norinco. seems to have some low serial #'s on it. only 750,XXX. is that an older modle? thanks |
|
went to the range yesterday to shoot off a few rounds. not bad for cheap rifle. anyway, I found out that after every few rounds the front site post would spin a bit changing where the impact was going to be. it seems to spin just by taping it. no tool needed. is there anyway to tighten it without changing the where the bullet will land? any info would help thanks |
AK Sponsor