AK Sponsor
Posted: 2/24/2006 2:08:47 PM EDT
|
I recently bought a WASR-10 and Im looking to replace the trigger on it with a new one. Anyone have any suggestions for new triggers, and how much they run for? This is my first Ak so Im still learning about them. Would it be hard to replace myself? Also would this help the trigger pull and trigger slap. Me and my dad both commented on how much you have to pull the trigger and our fingers were kinda sore after shooting today. Thanks for the help. |
|
Tapco has a G2 trigger (fire control group) that works very good. It runs around $40. It is very easy to install, and no more trigger slap. This guy has a page giving step by step instructions on how to correct the trigger slap without spending any money. http://www.gunsnet.net/Linx310/slapfix.htm |
| My Vepr started giving painful trigger slap at around 1000 rounds. I dremeled the disconnector to prevent contact and it has helped. However, I heard everyone with a G2 does not have trigger slap, so I upgraded. The pull is now about 1-2 lb and the hammer "catches" the bolt carrier quite often, but should not be a problem at the range. |
Check out my site www.MidwestArmory.com I have G2's for $35 & cheap shipping. The G2s work great and are easy to install. If you you type in coupon code 762 at check out Ill knock 5% off your total order
|
|
the only thing thats a bitch about the replacing the trigger is the shepprads crook.. install the hammer first and set the trigger in (do not put the trigger pin through) hook the spring onto the hammer pin set it down on the side then inseart the tirgger pin while holding it down with a punch or something.. other then that i just dremaled my stock trigger group.. the pull weight is fine for me.. *if i want it lighter i just stone the sear.* but i'm a DIY guy.. if you buy the G2 pick up the retaining plate or whatever it is that sheppards crook is a flipin nightmare sometimes.. Jess |
My Vepr came with a plate already. The worst part about doing the G2 install was shaving the safety so that it'd work properly with the G2. Otherwise, the G2 has a VERY light pull (1-2 lb). |
AK Sponsor