Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 2/21/2006 9:29:24 PM EDT
Got a new barrel on order from k-var, going to install it on a romie kit. Do i need to worry about headspace??? Also i tried searching, but i could not find any sort of barrel removal tutorial, any help would be appreciated. thanks.
Link Posted: 2/21/2006 10:11:06 PM EDT

Originally Posted By kooterthegoat:
Got a new barrel on order from k-var, going to install it on a romie kit. Do i need to worry about headspace??? Also i tried searching, but i could not find any sort of barrel removal tutorial, any help would be appreciated. thanks.



Yes the new barrel will have to be headspaced, there is no provision for the barrel pin so once headspace is done you will have to mill/drill the barrel pin groove on the barrel. For barrel removal referr to the BUILD IT YOURSELF section of this site. Personally i remove barrels with the pulley puller method, I've done 15 so far with that method, to install a barrel i beat them in with a hammer, with the receiver resting on a block of hardwood. McM
Link Posted: 2/22/2006 6:21:51 AM EDT
Thanks!!
Top Top