AK Sponsor
Posted: 11/23/2004 12:13:05 PM EDT
|
Just got back from a local gun shop, the location I will be purchasing a MAK 90 from within a couple weeks. They have three available, I checked the diameter of all three muzzles. Each came out to right about .505". It is my understanding that would be too small to thread to 14x1mm LH, correct? I would have to thread them to 1/2x28, then use an adapter to mount a 24x1.5 flash hider - yes? None of them had retainer pin holes in the FSB either. Would it be okay to mount a FH using red loctite? |
|
Okay - picked up my MAK 90 now - bought it FTF from a guy locally instead of one of the ones at the store. I haven't measured the muzzle yet to verify diameter, but I can still see the original turning marks - it should be large enough to thread at 14x1m LH (will check it soon). Question though - the FSB is not drilled for a retention pin/spring (or if it was, is been welded over and ground down). Since I plan on installing a FH - should I see about getting it drilled? Or will red loctite work to secure the FH? |
AK Sponsor