[ARCHIVED THREAD] - How Hard is it to . .

Posted: 5/12/2004 3:27:04 PM EDT

Change the handguards on a SAR-2? I was checkin out the kits on ironwood designs and was thinkin about it.

Posted: 5/12/2004 3:51:24 PM EDT

[#1]

About 1 minute of time. EASY.!!!!!!!!!

Posted: 5/12/2004 4:23:45 PM EDT

[#2]

a very simple task.

minor sanding/fitting of the new wood would be the toughest part of the job (and often this is not needed).

Posted: 5/12/2004 4:31:20 PM EDT

[#3]

I've found his handguards to be about 3mm too short. Not over all length, but the part that shows, if that makes any sense. Also, the upper handguard I just ordered is loose on the gas tube, as well as being too short. I'll send it back and request a change, but just a word of caution from my experiences. Thanks,

Schulze

Posted: 5/12/2004 5:22:31 PM EDT

[#4]

Ya sure your receiver front isn't too long?

Common problem with some receiver/kit combos.

Posted: 5/12/2004 5:59:26 PM EDT

[#5]

Receiver front? I checked the length on my Romanian '74, PMKMS, and a vented gas tube I have. All short.

Posted: 5/12/2004 8:14:52 PM EDT

[#6]

Five to ten minutes if it your first time doing it.

[ARCHIVED THREAD] - How Hard is it to . .

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - How Hard is it to . .

[ARCHIVED THREAD] - How Hard is it to . .