AK Sponsor
Posted: 5/25/2015 5:19:49 PM EDT
|
I'm looking to getting some work done to my SGL21. I want to cut the barrel down to 14.5, crown and thread the barrel then perm attach a muzzle device to it. My original plan was to run an AAC Brakeout 2.0 to run an 7.62 SDN-6 but I was told that the barrel is too thin to thread it in 5/8x24 and that I might run into a concentricity issues. Whats the best way to go about completing these mods? |
|
Quoted:
find one threaded 14x1LH? If you want to make sure it's concentric, you're going to have to take it to asmith that can pull the barrel and run it on a lathe. It's the only way to be 100% sure. +1 your barrel can be dialed in, re-profiled for the desired length of the threads, and have a 5/8-24 interference fit sleeve pressed on it. Or.... thread for 1/2-28 and have a 1/2-28 Brakeout bored. A much less expensive option will be to use a CNC Warrior 24x1.5 to 5/8-24 adapter. This may not yield a concentric result. |
AK Sponsor