AK Sponsor
Posted: 4/17/2012 8:55:05 AM EDT
|
I'm interested in putting a collapsible stock on my dual tang milled receiver. Does anyone know of a company that sells an adaptor to put an AR-15 style stock or a complete collapsible stock set-up that will work with the double tang?
Any help would be greatly appreciated. Thanks, cusima55 |
|
You had quite a wait from when you registered to when you made your first post. Welcome!
Unfortunately I don't have a very good answer for you. I just checked my kicklite stock and there is a spot on the bottom side of it where it looks like a lower tang might be mountable, but I don't know if it measures up correctly. ETA: http://www.tapco.com/products/ak_modern/index.php?_a=viewProd&productId=29 Will not fit on AK variants with a bottom tang, a slant-cut receiver at the rear, or an underfolder stock
I can't find anything that will work for you if you don't remove the lower tang. |
|
Ace makes a milled receiver block, to which you can install their skeleton stock and/or their folding mechanism. Length of pull might be a bit long for both the milled block and the folding mechanism, but that's one option I am aware of. The best part is, you don't have to remove any of the tangs.
ACE receiver block |
|
I was in the same boat... looking for buffer tube for milled AK to mount M4 style butt stock without removing lower tang. I contacted ACE about their adapter and they said it would NOT work with lower tang in place.
I also do not like the downward slant of the butt stock/tube on the TAPCO products. Command Arms does make two buffer tubes (one polymer and one metal) that will work with the lower tang in place. These also have a downward slant but not as severe as the TAPCO and appear very well made (handled both). In the end, I went with a Warsaw length fixed stock because a shorter LOP was my overall goal. |
AK Sponsor