AK Sponsor
Posted: 10/28/2010 4:32:41 AM EDT
|
So, I bought the mojo microclick. I was able to get it installed. But I am pretty sure something went wrong. The sight flops around. I am pretty sure it should not do that. Any suggestions???
Updated with pics 
|
|
Quoted:
Quoted:
The spring needs to be pushed into the RSB more. There should only be about 1/16th between the edge of the slot to the dot on the spring. What is the best way to do this? Take the sight off, and remove the spring. Make sure there is nothing stuck in the slot that the end of the spring goes in, and then push the spring back in until that dot is in the right place. Wiggle it around or use some pliers to push it in. You may have bent the spring getting the old leaf out though. |
I pulled the furniture. From the uderside of the spring, with the sight in place. Used Pin driver, gave it a few whacks with the brass hammer. It is in place nicely now. No more floppiness.
AK Sponsor