AK Sponsor
Posted: 10/23/2006 8:29:44 AM EDT
|
ok.. i only shot my gun twice so far. thank goodness with non corrsoive ammo.. any way i am having trouble finding a rod that ACTUALLY fits into my barrel. i have an ak74. shootin 5.45 x39 mm. unusually small what i'm used too. any one know what caliber or w/e i should use or osmething i tried this rod i got for a .223 i bought but to small(rod fits but when i put the cleaning cloth to the edge it will get stuck.. tried my one for my mosin nagant doesn't work to small. 2nd question is.. the first time i cleaned the receiver and gas chamber. the 'black powder?' i guess what you might calll it came off easily. but i tried cleaning it off with this generic brand crap and its stuck prettyt good onto the tip of the gas piston. any one know of good stuff to take this off. feels like paint coating on it. |
|
Sounds like a trip to Wal-mart is needed. Pick up the items listed below from each department. SPORTING GOODS DEPT. Universal rifle/pistol/shotgun cleaning kit(my local Wal-mart carries2 brands with this one being the best) http://secure.armorholdings.com/kleen-bore/product325.html Break-Free CLP http://www.break-free.com/?location=/products/index.asp .22 caliber bore brush 20 gauge bore brush small brush with metal brissels(if not here they will have them in the Automotive Dept.) AUTOMOTIVE DEPT. The cheapest plastic car floor mats A can of Brake parts cleaner A brush with metal brissels(brass or stainless steel) HOUSEWARES DEPT. Roll of paper towels DRUG DEPT. Tooth brush First thing when you get home swap the new tooth brush for your old one. Lay a floor mat on a table or workbench. Take the rifle apart and lay the parts on the floor mat. Shake the CLP well and spray all the parts and the rest of the rifle inside and out. Let everything soak for 15 mins. Then use the tooth brush to scrub all the parts and inside the receiver. Use the .22 bore brush on the barrel and the 20 gauge brush on the gas tube/gas block. Put 4 paper towels in the plastic bag that your purchaces came in. Shake the brake parts cleaner well and spray all the parts off while holding them over the plastic bag. Stick the barrel in the bag and spray the receiver/barrel to rinse off the gunk. Once the brake parts cleaner runs out the end of the barrel clear it is clean. The brake parts cleaner removes all the dirt/gunk,dries very quickly,and leaves no residue. Spray a 6"x6" rag and one cleaning patch till soaked with CLP. Use the rag to wipe down all the parts and the rifle inside and out so all metal parts are coated with CLP. Run the patch down the bore. Then put both rag and patch in a zip loc baggie for use next time you clean a firearm. Take a couple paper towels and wipe off the floor mat. Throw the paper towels in the plastic bag and set it outside till the next day so the brake parts cleaner evaporates then throw the bag away. I have been using CLP for over the last 15 years and it does a great job of cleaning,lubricating,and protecting all my firearms from rust. PS-make sure to wipe the gas tube,gas block,and gas piston down with CLP as it will make cleaning them the next time a lot easier as it doesn't let the firing residue stick as tight to the metal parts. |
AK Sponsor