Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 11/16/2003 11:26:26 AM EDT
I bent two pin punches trying to get the firing pin retaining pin out. Any suggestions?
Link Posted: 11/16/2003 5:11:28 PM EDT
Did you remove the "shepherd's hook" (the sping steel wire gizeewdiget) and un-couple the hammer spring first?

SD
Link Posted: 11/16/2003 5:35:59 PM EDT
I replaced my hook with an RSA retainer plate along time ago.

I'm actually trying to remove the retaining pin for the firing pin in the bolt.
Link Posted: 11/17/2003 9:38:12 AM EDT
Have you made sure that the notch for the retaining hook/plate is nto hanging up on the receiver after the pin moves about 1/8"
Link Posted: 11/17/2003 10:31:09 AM EDT
I'm not trying to remove the hammer or trigger pins. I'm trying to disassemble the bolt (i.e. the firing pin and extractor).
Link Posted: 11/17/2003 7:56:50 PM EDT
IIRC, the firing pin retaining pin is tapered so it only goes in and out one way, look at both ends, one end should be wider than the other. Also the firing pin retainer must come out before the extractor retainer comes out.
Link Posted: 11/18/2003 3:12:29 AM EDT
[Last Edit: 11/18/2003 3:21:22 AM EDT by CAMPYBOB]
Top Top