AK Sponsor
Posted: 2/14/2006 9:15:57 PM EDT
|
So lets say I pick up one of these Yugo milled underfolder kits from Centerfire systems. yugo kit from centerfire I know the front trunnion is set up for the thicker milled receiver, but my question is about the underfolder itself. Would it fit in a stamped receiver no problem? Also, if at some future point, could you remove this barrel and put it in a front trunnion for a stamped receiver with no extra fitting? |
| IIRC, the outside width of the milled receiver is the same as the outside width of the stamped reciever, so yes, I think the underfolder mechanism will work on a stamped reciever. I am on the road now, but if no one verifies I am right, I can double check my memory when I get home. But to use the UF on a stamped reciever, you will need to get a UF trunnion to fit inside the stamped reciever. It would probably be possible to make a trunnion by grinding down the milled reciever stub to the right thickness. Regarding the barrel, good luck getting one in good condition. |
AK Sponsor