AK Sponsor
Posted: 11/30/2005 2:07:39 AM EDT
|
I am going to try the build thing. Where can I find some blueprints so I can make a bend die for the flats? Thanks, new builder |
|
I am renting my jig (A DPH jig): www.quarterbore.net/forums/showthread.php?t=510 And I have the plans to build the 555th jig as well: www.quarterbore.net/forums/showthread.php?t=164 Good Luck! |
|
Thanks, Does anyone know where I can download the receiver print? Also a diagram of the trigger group. Why is the male part of the receiver flat dies made from 3 pieces? It seems to me that it could be one piece unless there is something I am missing. Thanks for all the help. New builder If you build it it will shoot. |
|
Right on the home page of this site. www.ar15.com/content/manuals/AK47ReceiverPlanRev2.pdf |
| Thanks, Looks like a 3 piece receiver. The bottom is 1/8" thick. If I were using a flat .040" thick would I use the outside dimensions or the inside dimensions of this print? I know the sides would be the same but the bottom section is 1/8" thick. I believe it would be better to keep the inside dimensions. 1.7 -.125= 1.575 The 1.575 dimension on the end is what I think I should go by. Does this make sense or am I thinking to much? |
AK Sponsor