[ARCHIVED THREAD] - Break/retaining pin question

Posted: 3/11/2005 5:59:11 PM EDT

I finally got my barrel threading kit in and threaded my first AK. This one was a WSAR-10 and did not come with the break retaining pin or spring. First who do I order these from? Second I asume the pin is held in by the front pin on the front sight. I have wacked on it, but can not get it out. Any suggestions? I was told they were inserted on the Romainian WSAR-10's from the right and you need to tap from the left is that correct? It looks like it is the same diamiter on both sides.

THX!

Posted: 3/11/2005 6:01:46 PM EDT

[#1]

BRAKE! BRAKE! FUCKING BRAKE!

what was the question again?

Posted: 3/11/2005 6:13:25 PM EDT

[#2]

WAMJR, from where did you get your barrel threading kit and how much was it, if you don't mind my asking!

RTO

Posted: 3/11/2005 6:35:04 PM EDT

[#3]

http://www.brownells.com/

I purchased the slant break, the die, and the thread alingment tool. Here are the part numbers and prices. I purchased 2 of the slant breaks to try out first.

246-199-003 199C SLANT STYLE MUZZLE BRAKE 2 14.50 29.00
246-199-005 199E M14 X 1 DIE 1 42.00 42.00
246-199-006 199F THREAD ALIGNMENT TOOL 1 14.50 14.50

WTF? Is up with the TheRedHorseman has he been drinking?

Posted: 3/11/2005 6:37:54 PM EDT

[#4]

no drinking tonite, except coffee(I work weekends)

just being a spelling nazi.

Posted: 3/11/2005 9:19:33 PM EDT

[#5]

I got my BRAKE and a detent pin and spring kit from Global Trades. It's listed under the AK sights.
I rented a threading kit from the Equipment Exchange for $20.

Posted: 4/4/2005 5:12:18 PM EDT

[#6]

testh.gif

Posted: 4/6/2005 6:55:19 AM EDT

[#7]

Quoted:
I finally got my barrel threading kit in and threaded my first AK. This one was a WSAR-10 and did not come with the break retaining pin or spring. First who do I order these from? Second I asume the pin is held in by the front pin on the front sight. I have wacked on it, but can not get it out. Any suggestions? I was told they were inserted on the Romainian WSAR-10's from the right and you need to tap from the left is that correct? It looks like it is the same diamiter on both sides.

THX!

Your right on all acounts!
the pin IS held by the front sight pin.
and yes even though they appear to be the same,
some remove better from the left.
And you can order the pin and spring from www.k-var.com.

Posted: 4/6/2005 10:36:24 AM EDT

[#8]

Scott Gull at www.dpharms.com had the springs and detent pins when I needed one for my SAR. Check with him. If it isn't on his website use the site contact button to email him, he may have a few and just not listed them.

[ARCHIVED THREAD] - Break/retaining pin question

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Break/retaining pin question

[ARCHIVED THREAD] - Break/retaining pin question