B-Square Front Site Tool > Build It Yourself

Posted: 10/19/2004 6:54:03 PM EDT

I'm looking for a way to get my Ak's sighted in properly and thinking about picking up the B-square Tool .Has anyone used this Tool ? Any Good ?

I don't care for the sight picture on the windage adjustable rear sites.

Posted: 10/20/2004 4:54:35 AM EDT

[#1]

Nope. C-clamp, two small sockets, extra hands. Smaller socket presses drum in, larger socket on the drum side heading out, turn clamp to suit.

Soak it in oil a few days before moving, so it's not stuck.

Posted: 10/20/2004 5:12:22 AM EDT

[#2]

Quoted:
Nope. C-clamp, two small sockets, extra hands. Smaller socket presses drum in, larger socket on the drum side heading out, turn clamp to suit.

Soak it in oil a few days before moving, so it's not stuck.

You know, I may need to try this. My SAR1 was fine out of the box but I am sure my luck will change soon enough!

Posted: 10/21/2004 10:25:07 AM EDT

[#3]

Quoted:
Nope. C-clamp, two small sockets, extra hands. Smaller socket presses drum in, larger socket on the drum side heading out, turn clamp to suit.

Soak it in oil a few days before moving, so it's not stuck.

Hmm...two sockets is a good idea! I've been using steel washers with electrical tape to keep them on the front sight base while using the C-clamp. For the sight elevation, I just made one out of a short piece of steel rod, dremel a slot wide enough to fit.

Warning

Confirm Action

[ARCHIVED THREAD] - B-Square Front Site Tool

[ARCHIVED THREAD] - B-Square Front Site Tool