AK Sponsor
Posted: 12/4/2008 5:08:36 PM EDT
|
I have a small problem. I have finished my build & the G2 dbl hook fire control group will not not fit inside my Nodacspud type 1 receiver because of it's single hook cutout.
Since I am not going to drill out the receiver. Do I test fit the trigger, pull & see where it binds up on the right side. then remove material from the r. hook reinstall, test again. until I get the trigger to engage & reset with the hammer? Forgive if this horse has been beaten to death. My search fu is weak. Has anyone seen a link to this procedure, or any positive input /help ? Thanks in advance. Jimmo |
|
I have already riveted the trigger guard on, so i would have to drill from the inside. prob not a difficult job to most - but these NDS receivers are hard as h#ll.
I have already parked & coated the receiver & if anyone could scratch,mar the finish it's me - I know it's an AK not a new car... Of the two parts to whittle on. The FCG would be the less expensive - at this point. J. |
AK Sponsor