[ARCHIVED THREAD] - Roll pin punch

Posted: 4/26/2010 6:45:52 AM EDT

What size punch do I need for the roll pin in my FSB?

Posted: 4/26/2010 7:21:22 AM EDT

[#1]

Just get the Model 1 Sales punch kit from MidwayUSA and you'll have all that you need.

Posted: 4/26/2010 9:34:23 AM EDT

[#2]

5/64" is the correct size, but a 1/16" will do.

Posted: 4/30/2010 3:59:40 PM EDT

[#3]

Adco makes a nice one that I use....has a nice little dimple to center the punch in the pin which allows you to place and retrieve without boogering it up....

Posted: 5/1/2010 11:03:15 AM EDT

[#4]

Quoted:
What size punch do I need for the roll pin in my FSB?

You have a roll pin, and not a taper pin?

Posted: 5/1/2010 11:47:45 AM EDT

[#5]

gas block roll pin is tiny...1/16" will work as mentioned above but don't get that punch driven into the hole itself.
Got a set of Proto roll pin starter punches, they are awesome, and don't bend.

Posted: 5/1/2010 3:32:43 PM EDT

[#6]

Quoted:
gas block roll pin is tiny...1/16" will work as mentioned above but don't get that punch driven into the hole itself.
Got a set of Proto roll pin starter punches, they are awesome, and don't bend.

My bad, I though he meant the taper pins (as in FSB removal.)

[ARCHIVED THREAD] - Roll pin punch

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Roll pin punch

[ARCHIVED THREAD] - Roll pin punch