[ARCHIVED THREAD] - Problem with my BAD-ASS-ST?

Posted: 1/21/2015 9:27:25 PM EDT

Parts involved:

JoeBob Spartan Lower
Black Rain Ordnance Drop in Trigger
BAD-ASS-ST Short Throw

Ever since I installed the new safety if I squeeze the trigger hard enough it will release the hammer with the safety engaged. If I squeeze the trigger lightly while the safety is engaged (take what little slack is up) when I disengage the safety it will drop the hammer without touching the trigger.

It didn't have this issue with the standard mil-spec safety. Anyone run into this problem before

Posted: 1/21/2015 10:06:23 PM EDT

[#1]

Sounds like something is off in tolerances. Have you contacted Black Rain? You may also contact Battle Arms Development, they are in Industry Partner here on the forums.

CY6
Greg Sullivan "Sully"
SLR15 Rifles
TheDefensiveEdge.com
(763) 712-0123

Posted: 1/22/2015 5:57:27 PM EDT

[#2]

I would swap out the trigger with a standard mil-spec trigger and retest to see if the issue is with the FCG or the safety first.

Posted: 1/22/2015 10:30:11 PM EDT

[#3]

Quote History

Quoted:
I would swap out the trigger with a standard mil-spec trigger and retest to see if the issue is with the FCG or the safety first.

View Quote

Posted: 1/23/2015 4:05:54 PM EDT

[#4]

My lower is out getting engraved right now but when I get it back I will throw a mil-spec trigger in and see what happens.

Posted: 1/27/2015 9:27:41 PM EDT

[#5]

Contact Battle Arms Development. They should take care of you.

[ARCHIVED THREAD] - Problem with my BAD-ASS-ST?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Problem with my BAD-ASS-ST?

[ARCHIVED THREAD] - Problem with my BAD-ASS-ST?