AR Sponsor
Posted: 1/3/2014 12:09:11 PM EDT
|
https://scontent-a-sjc.xx.fbcdn.net/hphotos-prn1/1560623_10153702099225013_89853214_n.jpg
https://scontent-a-sjc.xx.fbcdn.net/hphotos-frc3/1507600_10153702099220013_731575840_n.jpg ]I just put kns trigger pins on my JD lower and im getting a gap between the pins and the lower is this normal?? |
|
Quoted:
Remove some material from the ends of the pins until they are just flush with the receiver. That will take care of your problem. I was thinking about trying that I just didnt want to mess them up if I should send them back..... I think I will give it a go thanks!! |
|
Quoted:
Remove some material from the ends of the pins until they are just flush with the receiver. That will take care of your problem. I went ahead and did remove some metal only thing is the hammer pin i cant shorten it has little fins the keep it in line but the trigger pin is now perfect so at least it cant slid around thanks again |
AR Sponsor