AR Sponsor
Posted: 2/15/2009 4:29:55 PM EDT
| I was shooting today and shot 30 rounds of factory loads (fed) with no problems. 2nd mag with reloads that I have shot before with no problems, and it would shoot one round and eject, but would not load next round. Switched back to factory rounds and was ok for a while, then it started doing it on the factory rounds. Got back home and noticed the screws for the carrier key were loose. Would this cause the problem if they were loose? Also I tighten them back up, are the carrier key screws suppose to be torqued to a specific amount? Its a 16" Del-ton rifle. Thanks. |
|
It takes more that just re tightening the screws to 37 in lbs to make sure that that stay that way.
http://www.ar15.com/content/page.html?id=122 |
|
Quoted:
It takes more that just re tightening the screws to 37 in lbs to make sure that that stay that way. http://www.ar15.com/content/page.html?id=122 I found that post and will be re-staking it before the next range trip. Thanks for the replys. |
|
My DIY staking thread..........
http://www.ar15.com/forums/topic.html?b=2&f=130&t=160446 |
AR Sponsor