I bought a new Bushmaster M4 type 14.5 w/ Permanent Phantom (a six port kind w/o spikes) upper to go onto my old M4 lower. Long story, the lower is part of a bushmaster that was sold during the ban w/ fixed stock and y-comp. However, following the ban, the a3 upper was given an aimpoint, GG&G buis and ADCO attached a phantom (w/ closed bottom port, no spikes) and bayonet lug. The lower was given a rock river arms telestock asembly (all parts, buffer, spring, stock, tube, are all RRA). Then, this year I wanted an eotech. Being an AR kinda guy, I wanted to get both. So I ordered a the new upper and an eotech 512.

When I got the upper, I could tell Bushmaster's work had gone down. The front sight assembly was not filled down and had raised mold lines. (I know they have mold lines, but these stuck up about 2mm on the area holding the gas tube pin) I cleaned the rifle, got the grease out of it, and lube it. Then I begin to hear something like sand paper in my upper. It is the movement of my charging handle! hock.gif I've since shot and cleaned the rifle twice with no malfunctions, but my c-handle has been scraped along its edges. My old M4 upper does not have this issue. The new c-handle is especially sharp around the edges though.

After I broke my new AR in (I sighted it in with about 50 rounds and then ripped 180 through it, woah yeah!) I got home and gave it a cleaning. The upper has bushmasters dry-lube in it, which easily peels off after hoppes elite is applied, so easily, that I just removed it all, like my other upper is. I then see the buffer tube. In the center, there is a ring shape where the carrier has been hitting the buffer. It is slightly scraped and has been exposed to reveal the shiny metal beneath it. The ring is not very deep, not even 1mm, but is very rough. Is this an issue?have

.

Quoted: .

The rifle was cleaned, and lubed. I inspected the carrier today. No sharp edges or burrs on the back, but it fits a bit more snug to the buffer than my old one.hinking.gif