AR Sponsor
Posted: 8/20/2015 10:20:27 PM EDT
|
Hey all, I know ive been pesturing you guys off and on the past couple montths and you all have been a fantastic help with my first AR build. Anyway, I finally finished it, will probably take it to a local gunsmith to have him double check the head spacing and all that before firing it, but anyway, heres the finished gun.
It has a anderson manufacturing lower, Aero Precision upper (rebranded SAA) A 18" wylde barrel from Integrity arms, a diamondhead 13.5 inch handgaurd, spike comensator, magpul stock, mag, and trigger gaurd, and a ATI scorpion grip, with ambidextrous safety. The scope on its a cheap simons, until I can get a better one, and i am planning on upgrading the charging handle to a rainer raptor ambidextrous charging handle at a later time when funds are more plentiful. 
|
|
Can you get proper eye alignment with the scope mounted that low? Look into taller rings if you can't. Most get mounts to put the center of the scope about 1.5" above the rail and use ultra high rings.
There are extended latch replacements you can get and keep the CH you have. With a scope you will want one and they are cheap. Nice looking rifle. |
Nice rifle
|
New rings are on the list, it was difficult to shoot. Right now I'm on a budget, but they are going to be replaced at some point in the future.
I'm also planning on changing out the charging handle with the Rainier arms ambidextrous charging handle and adding a fore grip/bi-pod combination at a later date, just can't right now due to budget limitations. |
AR Sponsor