[ARCHIVED THREAD] - Gas block?

Posted: 3/7/2015 10:05:53 AM EDT

Does anyone know if the set screw spacing on the YHM-9383 low profile gas block is pretty much the same as all the other lo pro gas blocks. I made a jig to dimple the barrel out of a YHM gas block and was wondering if i could use any others, or just stick with YHM. Any info would be greatly appreciated.

Posted: 3/7/2015 10:08:27 AM EDT

[#1]

You only need to dimple once. ALL setscrew blocks have one of their setscrews directly opposite the gas port, which makes things much easier when you're trying to figure out where to drill the dimple.

Posted: 3/7/2015 11:46:28 AM EDT

[#2]

It's the same

Posted: 3/7/2015 1:51:27 PM EDT

[#3]

Okay, thanks. Any recommendations, any gas block better than another?

Posted: 3/8/2015 9:16:42 AM EDT

[#4]

Anyone out there ever use this gas block. It seems very cheap, but there has been 235 sold and I can't find any negative feedback.
http://www.ebay.com/itm/Micro-STEEL-Low-Profile-223-Gas-Block-Roll-Pin-for-750-barrel-w-Roll-Pin/261689798082?_trksid=p2050601.c100269.m3464&_trkparms=aid%3D111001%26algo%3DREC.SEED%26ao%3D1%26asc%3D20140813133143%26meid%3D753feaacf8ab4a94a53fdcff793cd129%26pid%3D100269%26rk%3D1%26rkt%3D4%26mehot%3Dpp%26sd%3D261689798082%26clkid%3D4581616902940192482&_qi=RTM2062264

[ARCHIVED THREAD] - Gas block?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Gas block?

[ARCHIVED THREAD] - Gas block?