i have an lrb lower with a cmmg lower parts kit my problem is the trigger is too high to hammer the pin into the lower it doesnt match up with the lower so what can i do ?
Posted: 1/15/2013 7:54:56 AM EDT
[#1]
never-mind delete please it was the spring catching on the side of the receiver
Posted: 1/15/2013 7:55:26 AM EDT
[#2]
Having a hard time picturing this, is it that the trigger spring is holding the trigger pin hole up and you need to hold it down with your hand while placing the trigger pin through the lower and trigger pin hole?
Posted: 1/15/2013 7:56:51 AM EDT
[#3]
never-mind delete please it was the spring catching on the side of the receiver haha i was getting all pissy about it not fitting but nevermind i took the spring off the trigger and it does go all the way do my bad everyone ...... duhhhhhhhh
