AR Sponsor
Posted: 1/6/2013 7:19:07 PM EDT
|
I have compiled the following parts since 24 Dec:
Rock River Arms Complete Lower Half / Standard Trigger / 6-Position Tactical CAR Stock Spikes Tactical Upper Receiver - Forged M4 Flat Top FailZero AR-15 Bolt Carrier Group BCMGUNFIGHTER Charging Handle (5.56mm/.223) w/ Mod 4 (MEDIUM) Latch BCM Low Profile Gas Block BCM Mid-Length Gas Tube PSA 16" 5.56mm, 1:7, CMV CL MP, Mid-length, Premium Barrel - Pencil Profile A2 Flash Hider Daniel Defense Modular Float Rail 12.0 Pretty impressive considering the climate. Are there any more components that I am missing? I plan to have a gunsmith assemble the upper half. Comments? Suggestions? Thanks in advance. |
|
Quoted: I have compiled the following parts since 24 Dec: Rock River Arms Complete Lower Half / Standard Trigger / 6-Position Tactical CAR Stock Spikes Tactical Upper Receiver - Forged M4 Flat Top FailZero AR-15 Bolt Carrier Group BCMGUNFIGHTER Charging Handle (5.56mm/.223) w/ Mod 4 (MEDIUM) Latch BCM Low Profile Gas Block BCM Mid-Length Gas Tube PSA 16" 5.56mm, 1:7, CMV CL MP, Mid-length, Premium Barrel - Pencil Profile A2 Flash Hider Daniel Defense Modular Float Rail 12.0 Pretty impressive considering the climate. Are there any more components that I am missing? I plan to have a gunsmith assemble the upper half. Comments? Suggestions? Thanks in advance. Really don't need a gunsmith to assemble any of it but that's up to you. Whatcha gonna use for sights or an optic? That's all I can think of looking at your list. Other than some roll pins I think you've got it all down. |
| Was your upper reciever complete or stripped? If stripped need forward assist and a ejection door cover. You'll need some buis and a gas tube roll pin. Don't be worried about putting it together yourself it's not very hard and after you do it you'll feel great about it. All you'll need is a barrel wrench from DD a torque wrench and a vise block which can be made out of a 5 dollar cutting board. There are tons of tutorials on this site that will walk you through the process. |
|
Quoted:
Was your upper reciever complete or stripped? If stripped need forward assist and a ejection door cover. You'll need some buis and a gas tube roll pin. Don't be worried about putting it together yourself it's not very hard and after you do it you'll feel great about it. All you'll need is a barrel wrench from DD a torque wrench and a vise block which can be made out of a 5 dollar cutting board. There are tons of tutorials on this site that will walk you through the process. Stripped. I'm getting an upper parts kit from Rainier. The BCM gas tube includes the roll pin. I have Magpul MBUS buis, front and rear. |
AR Sponsor