[ARCHIVED THREAD] - Safety Selector Removal

Posted: 12/29/2012 8:14:28 AM EDT

I am attempting to install an ambidexterous selector. However, i can not remove the existing selector. The machined shoulder will not clear the trigger not allowing the selector to slide out.

Does anyone have a fix not involving a large hammer?

Posted: 12/29/2012 8:19:23 AM EDT

[#1]

remove your trigger if its in the way

eta: cock the hammer and put the selector on safe and see if it slides out, im not sure why it would be catching

eta2: you did take the grip, spring, and detent out right?

Posted: 12/29/2012 8:28:49 AM EDT

[#2]

pin and spring removed

hammer cocked and on safe

will not slide out

Posted: 12/29/2012 8:52:34 AM EDT

[#3]

then i would remove trigger to insure it is out of the way and safe, and that means nothing else left, may be a bur holding it up and you may have to give it a little tap

[ARCHIVED THREAD] - Safety Selector Removal

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Safety Selector Removal

[ARCHIVED THREAD] - Safety Selector Removal