AR Sponsor
Posted: 7/22/2011 6:20:05 PM EDT
| I am working on my first build right now. I am currently building the lower, a spikes zombie receiver and a CMMG parts kit. Right now I am having trigger problems. When the hammer is engaging the disconnector and I release the trigger, the hammer is not catching the sear and falling all the way forward. What could be causing this? Thanks! |
|
oh i read yours wrong i think... your hammer is going all the way forward as in the fully upright "fired" position ?
my problem was once pulling the trigger, and holding the trigger while pulling the hammer back, it would lock back and not do the slight "click" forward when the trigger was released |
|
Quoted:
I am working on my first build right now. I am currently building the lower, a spikes zombie receiver and a CMMG parts kit. Right now I am having trigger problems. When the hammer is engaging the disconnector and I release the trigger, the hammer is not catching the sear and falling all the way forward. What could be causing this? Thanks! Most likely disconnector spring in up side down or a disconnector timing issue ... but also check your hammer spring to make it's installed correctly. |
AR Sponsor