[ARCHIVED THREAD] - Stock Wrench

Posted: 1/30/2010 8:00:21 AM EDT

I'm working on my BCM build and its time to install the buffer tube. I don't want to spend $35 on an ar-15 muilti tool that ill only use once. Is this a good option to install a buffer tube? http://www.aimsurplus.com/product.aspx?item=XPM095&groupid=57

Posted: 1/30/2010 8:04:48 AM EDT

[#1]

That one will work, but it's much more likely to slip out and scratch your receiver.

Try this one:Tactical CAR stock Wrench I think CTD has it for less than $10.

Posted: 1/30/2010 8:18:06 AM EDT

[#2]

i used the RRA one posted above and it worked perfectly.

Posted: 1/30/2010 12:04:02 PM EDT

[#3]

I went my first 9 years of AR ownership without one, just tightening by hand. Occasionally would have to re-tighten it, however I did once lose a detent spring. Find someone in your hometown forum that has one and borrow it.

Posted: 1/30/2010 2:08:50 PM EDT

[#4]

i used a large set of pliers.

yes, i did scratch it.

no, i don't care.

yes it is on there tight

i'll swap the whole stock out for an ubr once i get a rail.

[ARCHIVED THREAD] - Stock Wrench

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Stock Wrench

[ARCHIVED THREAD] - Stock Wrench