AR Sponsor
Posted: 8/21/2009 6:51:38 PM EDT
|
Conical shaped spring, slated as the disconnector spring, no way in hell will it fit all the way into the trigger recess so the disconnector can sit down inside where it is supposed to be that allows a builder to get the frikken pin through it...after several tries, the spring is now in low earth orbit.
Am I doing something wrong ? Everything else has gone together very well, and using the tip (s) here, I advise the taped up vice-grip method on the roll pins. And oh yeah, the trigger and hammer pins should be checked for fit before you try hammering the fuck out of them to make them work. Do not ask me how I know this, it is, afterall, my first AR build... And oh yeah again...DO NOT USE DUCT TAPE. |
|
I used very nice instructional video from internet how to install parts in lower, but guy forgot to mention that disconnector spring goes wide end down. He is a real............ and .........
It looks like a lot of guys use that video because everybody makes exactly same mistake. |
|
My buddy gave me an extra parts kit (DPMS) and i managed to get the spring in and the rifle is TOGETHER !
BTW, CLP works great for removing duct tape adhesive residue... 
Managed to put the rifle together without marking it up at all, I NEVER would have been able to do this without all the help from ARFCOM. Thanks fella's, your advice is very much appreciated. |
AR Sponsor