How do you lineup the gas block to the gas hole of a barrel if it does not have taper holes?
Posted: 6/29/2009 11:30:48 AM EDT
[#1]
i have always just eye balled it, the hole in the block is larger to allow some error.
Posted: 6/29/2009 12:00:11 PM EDT
[#2]
I eyeball it and then plug the barrel end and blow through the other end. you will feel how much or little resistance you have. You can also tell by how much and how hard the air comes out of the other end of the gas tube.
Posted: 6/29/2009 4:00:21 PM EDT
[#3]
Pencil a line to mark the center forward and aft on the barrel and pencil mark the gas block. Real easy and no guessing.
