AR Sponsor
Posted: 6/5/2009 6:52:06 AM EDT
| What sizes do I need for working on my AR? Does it matter what there made out of? Thanks |
I just purchased this kit to make sure I had everything I needed. Rick is a super great guy and I look forward to putting together my lower with the right tools from the get go. Good Luck and have fun!
http://www.ar15.com/forums/topic.html?b=7&f=125&t=635955 |
|
Quoted:
So is that all you need as far as punch goes, is just that one? I hope to not use a punch at all unless absolutely necessary. Here is a great do it yourself thread demonstrating the vice grip method. http://www.ar15.com/forums/topic.html?b=3&f=4&t=226782 |
|
you'll want starter punches too for the difficult pins, also a short shaft 1/16" pin punch to start gas tube roll pins.
More info here |
AR Sponsor