AR Sponsor
Posted: 2/11/2009 11:12:04 PM EDT
|
Ok, putting together my first LPK and I took a break to not break anything.
My Bolt Release is very weird, and it's not even installed. When placed in the littele channel it runs in, it sticks. I am using a RRA LPK and RRA lower. <sigh> What's the issue here? I'm not going to start forcing anything because if I break or lose it it will be monts until I find the parts for sale again. I thought this would be relatively easier than taking about my USP completely and taking it from V1 to LEM...but not so much... |
|
Quoted:
Hammer is not installed. there is no upper around either. If I were to try to completely install it, it would catch on the channel and not move freely. Quoted:
Its sticking inthe channel. I havent completely installed it yet. (aka tapped in the rol pin) Damn man, I feel like I'm just going to ask you another stupid question. Don't take it wrong. Did you fit the bolt release before you started the roll pin? It isn't just pushing it over to the side is it? |
|
Look for flash in the channel as well as burrs or whatever on the part itself.
Take a bit of emery or whatever and gently sand the channel etc. If it's just catching a tiny bit, it will clean up and run fine. If you get it to where it's just a bit tight oil it up, install it and work it back and forth until it loosens up. |
|
Ok, looked over it and the bolt release slightly bent. It's happening at the button/pivot area.
A buddy is doing a build with the same parts. His release fits fine in my lower, and my release has the same problem in his lower. Upon inspection it is visably canted. Called Rock River and I'm waiting for a tech to call me back. |
AR Sponsor