[ARCHIVED THREAD] - Assembling FCG question????????????????

Posted: 6/3/2008 10:26:05 AM EDT

I took my trigger out of my LMT to have it tuned and put it back in. However, I installed the trigger first but then couldn't get the selector through in any position (I know "fire" is correct) because it hit the trigger. So, I put the selector in first, then the trigger and was GTG.

So, if I want to take the trigger and hammer out again, do I need to remove the selector, as I could assemble them with the selector in place?

Posted: 6/3/2008 10:37:28 AM EDT

[#1]

should be able to remove the hammer without messing with it, trigger might require removal though.

Posted: 6/8/2008 9:59:58 AM EDT

[#2]

Should work either way, but the safety and trigger are a very close fit.

Posted: 6/8/2008 1:30:03 PM EDT

[#3]

Got the factory one out but couldn't get the match trigger in with the safety in place. Thanks.

[ARCHIVED THREAD] - Assembling FCG question????????????????

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Assembling FCG question????????????????

[ARCHIVED THREAD] - Assembling FCG question????????????????