Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
7411 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
springfield
fightlite
cz
palmetto
DFC
geissele
JRH
silencerShop
midwest
colt
primaryArms
skd
aim
brownells
vortex
OSIGHT
bravocompany
Guns
GS
magpul
Holosun
RS
7411 Online
cz
DFC
springfield
skd
Guns
brownells
aim
palmetto
JRH
magpul
bravocompany
vortex
Holosun
colt
RS
fightlite
GS
geissele
silencerShop
primaryArms
midwest
OSIGHT
AR Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
9/3/2007 6:38:37 AM EDT
Guys...was thumbing through Sweeney's book on the AR-15 the other day at a bookstore. One of the pages had a sight installation jig that mechanically lined up the front sight with the rear carry handle/sight. Looked like some square maybe aluminum stock or something that allowed the gunsmith/assembler to square everything up. None of the usual gunsmithing tool vendors seem to have it.

Any suggestions???
9/3/2007 7:30:52 AM EDT
[#1]
Use drill rod turned to fit within the slot on the carry handle, one end flat and the other turned to a point. You'll need a different one for each length of gas system. Check them periodicaly on a surface block for true.
AR Sponsor
cmmg
THBRD
blackhills
RS
palmetto
geissele
SAS
LAPG
primaryArms
LAPG
springfield
silencerShop
fightlite
bravocompany
ar15com
ar15com
CA
ar15com
colt
Faxxon
brownells
Pro2A