Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
17148 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
silencerShop
bravocompany
magpul
Holosun
palmetto
springfield
fightlite
cz
JRH
midwest
GS
vortex
aim
RS
geissele
colt
primaryArms
Guns
brownells
DFC
skd
CA
17148 Online
fightlite
vortex
midwest
DFC
aim
silencerShop
skd
RS
Holosun
bravocompany
springfield
JRH
CA
geissele
palmetto
GS
Guns
primaryArms
brownells
cz
colt
magpul
AR Sponsor
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
7/20/2007 7:17:55 AM EDT
I am almost finished with assembling my first lower and I have a question about my castle nut.  I looked at the thread to see how to assemble it and noticed that my castle nut doesn't have the cut outs to stake it.  I was planning on staking the castle nut so what do I do?

front of castle nut


back of nut
7/20/2007 7:22:21 AM EDT
[#1]
Thread it on the receiver extension with the wrench cutouts forward (toward the lower receiver).
Tighten the castle nut and stake into the wrench cutouts .
7/20/2007 8:13:00 AM EDT
[#2]
that's what i was thinking of.  It was the opposite way in the guide to i just didn't know if it made any difference.  thanks
AR Sponsor
colt
ar15com
ar15com
blackhills
ar15com
RS
LAPG
geissele
palmetto
fightlite
brownells
silencerShop
bravocompany
SAS
gray
springfield
LAPG
THBRD
cmmg
primaryArms
Pro2A
CA