AR Sponsor
Posted: 11/7/2006 8:12:13 PM EDT
|
hed but i think i got it right http://i51.photobucket.com/albums/f396/rmyc/DSC01576s.jpg http://i51.photobucket.com/albums/f396/rmyc/DSC01579s.jpg test fit http://i51.photobucket.com/albums/f396/rmyc/DSC01578s.jpg build http://i51.photobucket.com/albums/f396/rmyc/DSC01581s.jpg http://i51.photobucket.com/albums/f396/rmyc/DSC01582s.jpg http://i51.photobucket.com/albums/f396/rmyc/DSC01584s.jpg http://i51.photobucket.com/albums/f396/rmyc/DSC01586s.jpg A TRICK!! http://i51.photobucket.com/albums/f396/rmyc/DSC01580s.jpg hold the detent's end with a plier , press it in the hole and have some one tape it down.. remove pliers then tighten the tape down.. semi-insert the pin then remove the tape..finaly push the pin through all the way... Voala! Final http://i51.photobucket.com/albums/f396/rmyc/DSC01586s.jpg sorry about the shitty pics from a cell phone.. mods to come: 4 rail hand gaurd, scope,sling, vertical grip, bipod, stock, buis iron sights now the big question.. where's the cheapest place i can get ammo? i'v heard of $3/bx but havent seen any anywhere |
|
Yes i put the spring in.. the spring actually works against the bolt catch, so that wouldnt affect it. |
Bolt hold open does not work like that, to get the bolt to hold open when not done firing a mag you have to manually use the bolt catch |
Your right there...but it sounds like he is inserting an empty mag and the bolt wont automatically stay back. Can you try a different mag? Also lube up the bolt catch assembly where you pressed the pin thru. Sometimes the holes on new lowers have anodizing inside of them and it can make for a tightened area until it loosens up I generally run an appropriate sized drill bit into the bolt catch, front t/d pin, rear t/d pin and the hole for the safety detent and spring to clean them out a bit before building Other than that, it all looks good |
Reading is fundamental! Check another mag and tell me if that works |
it locks open.. but only some times.. the springs have to be broken in.. i'm going to try to lube them later, i just need to figure out what kind of lube to buy.. right now i'm figuring out my sights.. i'm thinking scoped for now (3-9x40). Ive been doing small bore .22 sharpshooting for a long time thus it's nice not to hive iron sights. need to get a quadrail than figure out where i can find a full length top rail to mesh the handgaurd and flat top together. FYI i'm going to get a 2pc had gaurd, i'd love a free float. but from where i'v read i'd have to grind off the muzzle break and weld/pin a new one. to much work for a toy |
Love the classic CAR stock.| I had a lower parts kit that had a bolt catch with an out of spec pin hole that was so tight that it wouldn't allow the catch to work with just the mags spring pressure. I had to get a new bolt catch and install it. Now everything works fine. Now I try pins for fit in everything before it goes in the receiver. |
I got real good mags with Magpul internals. it's the bolt catch spring that need to be broken in. initialy in the build, i had a hard time putting the spring in the hole becuase of the anodization. it's getting better everytime a press the bolt catch |
AR Sponsor