I'll check it out. Also a bit of discussion on pin holes in the Superior thread.
Posted: 7/15/2006 2:30:36 AM EDT
[#3]
I would look elsewhere if I was looking for the correct numbers.
Posted: 7/16/2006 2:07:45 PM EDT
[#4]
I can't get the print link to open. I even tried typing it in as a www. What am I doing wrong?
Posted: 7/16/2006 3:20:07 PM EDT
[#5]
Need Adobe reader it is a pdf file.
Posted: 7/16/2006 8:02:14 PM EDT
[#6]
Hey. I knew that. I had tried several times. I just tried again and used the "open in new window" and it worked. Pin hole size is .1560" + or - .0015". The receiver I'm working on seemed kind of loose but meets spec at .1570". Thanks again!
